DORC Interferometer for Fiber Optic Connector end face geometry testing. This non-contact interferometer is in very good condition and comes with Computer, control hardware and software, 2.5mm and 1.25mm connector holding fixtures, user manual and vibration isolation table. * Single unit can measure PC/APC connectors, ferrules, ferrule blanks, fiber cleaves, angled fiber cleaves and ribbon fibers * Automated measurements for radius, apex offset, fiber height, key error and fiber/ferrule surface roughness using DORC's intuitive Windows XP® Professional based PMS software * Extremely accurate and repeatable non-contact measurements in less than 1 second * Extensive reporting, archiving and statistical analysis capabilities * Automated scratch analysis * Integrated control of popular IL/BR meters * Available with dual-source extended range, for measuring fiber heights up to + 6mm * Compliance with all "Standards Organizations" measurement methods worldwide * Electronically controlled zoom objective, inspection and interferometric modes * Fully enclosed vibration and contamination insensitive design * Solid state illumination - no bulbs to change * Low maintenance and automatic calibration (please look at our rules and privacy policy) |
bobbi-robinson@modularparts.com (Bobbi Robinson)
for more information. This email will be sent to Bobbi Robinson' actual email address.