|
Microchip PIC 18F2450-I/SP 28 Pin USB v2.0 SDIP Flash Microcontroller New - Stock Item - OEM Quantities Available Tennessee Residents must pay sales tax unless a resale certificate is on file. * Flash Program Memory: 16k bytes * SRAM Data Memory: 768 bytes Universal Serial Bus Features: * Low Speed (1.5 Mb/s) and Full Speed (12 Mb/s) * Supports Control, Interrupt, Isochronous and Bulk Transfers * 256-Byte Dual Access RAM for USB * On-Chip USB Transceiver with On-Chip Voltage Regulator * Interface for Off-Chip USB Transceiver * Run: CPU on, Peripherals on * Idle: CPU off, Peripherals on * Sleep: CPU off, Peripherals off * Idle mode Currents Down to 5.8 μA Typical * Sleep mode Currents Down to 0.1 μA Typical * Timer1 Oscillator: 1.8 μA Typical, 32 kHz, 2V * Watchdog Timer: 2.1 μA Typical * Two-Speed Oscillator Start-up Flexible Oscillator Structure: * Four Crystal modes, including High-Precision PLL for USB * Two External Clock modes, up to 48 MHz * Internal 31 kHz Oscillator * Secondary Oscillator using Timer1 @ 32 kHz * Dual Oscillator Options allow Microcontroller and USB module to run at Different Clock Speeds * Fail-Safe Clock Monitor: Allows for safe shutdown if any clock stops * High-Current Sink/Source: 25 mA/25 mA * Three Timer modules (Timer0 to Timer2) * Capture/Compare/PWM (CCP) module: * Capture is 16-bit, max. resolution 5.2 ns * Compare is 16-bit, max. resolution 83.3 ns * PWM output: PWM resolution is 1 to 10-bit * Enhanced USART module: LIN bus support * 10-Bit, Up to 13-Channel Analog-to-Digital Converter module (A/D): * Up to 100 ksps sampling rate * Programmable acquisition time Special Microcontroller Features: * C Compiler Optimized Architecture with Optional Extended Instruction Set * Flash Memory Retention: > 40 Years * Self-Programmable under Software Control * Priority Levels for Interrupts * 8 x 8 Single-Cycle Hardware Multiplier * Extended Watchdog Timer (WDT): Programmable period from 4 ms to 131s * Programmable Code Protection * Single-Supply In-Circuit Serial Programming (ICSP) via Two Pins * In-Circuit Debug (ICD) via Two Pins * Wide Operating Voltage Range (2.0V to 5.5V) For your convenience a full copy of the specs are located here: http:// /pdfs/PI05.pdf Click on image for EVEN larger photo (please look at our rules and privacy policy) |
Ivy-vazquez@modularparts.com (Ivy Vazquez) for more information. This email will be sent to Ivy Vazquez' actual email address.
