|
PLEASE CONTACT US FOR PROPER DIMENSIONS AND WEIGHT FOR FREIGHT COST. Used 16" X 60" Victor engine lathe model 1660, swing over bed ways 15 3/4", Swing over cross slide 9", swing in gap 23", spindle nose D1-6 camlock, spindle bore 2", spindle speeds 65 - 1800 rpm, 5 hp., 220 v., 3 ph. Like new Bison 10" 3 jaw chuck, brand new steel change gears ($600.00 value) - replacements for nylon tooth style. MACHINE DOES NOT HAVE steadyrest, followrest or coolant pump. Machine came out of a wallcovering co. primarily used to clean build up off of rollers. By the looks of machine it did very little metal cutting at all. All spindle speeds have no excessive noises indicating wear or heavy use. All feed ranges are the same way. The machine shows very little use. We did repaint the cast base and behind the lead screw only due to the fact the factory filler was cracked causing paint to chip off - common to these lathes. (please look at our rules and privacy policy) |
Larry.faulkner@modularparts.com (Larry Faulkner) for more information. This email will be sent to Larry Faulkner' actual email address.
