|
Heat Sealer TEFLON COVER 36yd roll 5 mil 1.125" wide TEFLON FABRIC COVER 36yd roll 5 mil 1.125" wide This is the tape (non-adhesive) to use to cover the heating element on Impulse Sealers. This Fibreglass reinforced Teflon fabric tape prevents your Poly bag or Shrink film from sticking to the heating element. The roll is 36 yards x 5 mil x 1.125 wide. These will fit most hand sealers such as TEW-200, TISH-200 FS-200 WHEN LOOKING AT OTHER KITS MAKE SURE YOU ARE GETTING THE PROPER PARTS NECESSARY FOR A PROPER JOB, YOU SHOULD HAVE THE FOLLOWING * 1 REPLACEMENT Element (wire) * 1 Teflon Fabric 5 mil cover that goes over the element 1.125" wide * 1 Piece of 1/2 inch teflon tape(adhesive) 10 mil that goes under the element. Failure to replace the teflon tape that insulates the element from the body of the sealer will cause premature failure of the element and may cause failure of the timing circuit or transformer. (please look at our rules and privacy policy) |
howard-knapp@modularparts.com (Howard Knapp) for more information. This email will be sent to Howard Knapp' actual email address.
